Very first, automatic balers tape stuck, unable to carry out normal belt.(tape dispenser)
1. In accordance together with the order of the associated fixed wheel nut removed;
2. The shaft is going to be identified in connection with two specific head screws, since this is a fixed orifice connecting shaft made use of, it can be required to screw up the rotation;
three. Then you definitely can eliminate the connecting shaft to check the tape jammed reason, a foreign body, then it can speedily cleared;
four. Adhere to the preceding actions, then re-assembled automatic balers, to keep a specific gap amongst the key nut and curved panels. Packaged with at least greater than the thickness
Second, the automatic strapping can not automatically carried out together with the perform. Initially you have to verify packaged together with the linked handle method is standard, no matter whether the adjustment with extended positions within the zero scale, after which check through the entire method of compliance with standards, generally, you’ll find not blocked, causing the phenomenon.
Third, immediately after the completion of your job package, automatic balers can not be automatically cut tape.
1. Adjust packaged with tightness;
2. Check the automatic balers slip sheet and belt for oil, if loose, it desires to become cleared;
3. You could use a relatively thin strapping for packaging, in order that the roller gap narrowed much more.
Fourth, packaged with the adhesive strength of little, loose.
1. The adhesive temperature need to be moderate, as well higher or too low can not guarantee that the adhesive effect;
2. Automatic balers voltage provide shortage, will make the actual bonding temperature reduce than the bonding temperature previously set, unable to meet the relevant requirements, the use of the cable is also lengthy, it is going to have an effect on the voltage;
three. The automatic balers’s sword bearing damage occurs, the bonding temperature can not go up;
The spring pendulum failure, can not obtain the desired operating position, smaller area bonding;
five. The electric height of steel can not be the ideal combination, resulting in heating position deviation;
Fifth, it might not be normal continuous packaging.
1.LS5 faulty;
two. Verify regardless of whether there are contacts among the foreign physique and shrapnel, shrapnel stuck in that case, is not going to automatically packaged using the liberalization of the subsequent wrapper;
three. The circuit connection point is just not closed, as long as the energy is turned on it.
Sixth, automatic balers packaged with only packaged proceeds shear zone.
1. The machine re-adjust the tightness;
two.LS3 and LS5 place confusion, the position deviation;
three. The automatic balers back having a switch failure.